AVE DRT16 Uživatelský manuál stáhnout pdf (Strana 40)

• Area Threshold

<Area Threshold> indicates the motion alarm triggered level; if the

percentage of triggered grids to total detection area is greater than

the set value, the motion alarm will be triggered.

For example, if 10 grids are selected and the <Area Threshold>

value is 70%, the motion alarm will be triggered when seven grids

are motion detected.

Click UP / DOWN arrow keys to adjust the value. The value is

indicated in 4% increment.

Note that every time you have changed the value, remember to click

on “Apply” key to make the change take effect.

After the change(s) have been made (remember to click on “Apply”),

click to start detecting; click to stop detecting; click

to select all grids; and click to clear all selected

grids.

Alarm In

This item allows user to enable / disable alarm input detection. According to

your application, select <N/O> (Normal Open) or <N/C> (Normal Close) to

enable the alarm input detection or select <OFF> to disable the detection.

The default setting is <OFF>.

If you set this item to <N/C> but did not install any device to the unit, the alarm

will be triggered and the Event Icon displayed continually until this item is

changed to <N/O>, <OFF> or install a device to the unit.

Alarm Out

This item allows user to assign an alarm on certain channel to activate the

relays. These signals can be used to drive a light or siren to caution an alarm

event.

Select from the options: <A Only> indicates “Alarm Out A”, <B Only> indicates

“Alarm Out B”, <Both> indicates “Both Alarm Out” and <None> indicates “No

Alarm Out”. The default setting is <None>.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46

Žádné komentáře

AVE DRT16 Uživatelský manuál Strana 40